If needed, use fine sandpaper and alcohol wipes to remove corrosion and dirt. Assure the terminals on the battery and unit are clean.Check if the battery is loaded properly by pulling it out and pushing it back into position until you hear the snap.If the capacitor is bulging or blackened, it needs to be replaced with a new one. Next, check the capacitor inside the motor by removing the outer casing with a screwdriver.Any blown fuses will need to be replaced. If these solutions don’t work, your problem is likely more serious and will require you to do some mechanical work. If you’ve been using the unit and the motor feels hot, the circuit breaker in the unit may have tripped.For cords over 25 feet, size up to 12 gauge. In general, you’ll need a 14 gauge or heavier cord for these machines. Assure the extension cord is adequate for running the unit.Check the extension cord to ensure there is no damage to the line.Assure the unit is plugged in and that the outlet is working correctly.Open the motor housing and locate the flywheel then remove it to locate the flywheel key.Test this using an all-in-one spark tester or an ignition coil tester. A faulty ignition coil can also cause a gas unit to fail to start.Start by checking the spark plug by removing it from the unit and using a spark plug tester.If these solutions don’t work, you’ll need to do some testing and replace some parts to restore your pressure washer. If the carburetor looks dirty, use a carburetor treatment to unblock it.If the gas has been sitting in the unit for some time, drain it and replace it with a fresh mix. Check your gas level and assure there is enough gas to power the unit and that the fuel mix used is correct according to the user’s manual.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |